5) 是否设置异步口的PPP参数:
Configure for Dial-in IP SLIP/PPP access? [no]: yes
6) 是否使用动态IP地址:
Configure for Dynamic IP addresses? [yes]:
7) 是否使用缺省IP地址:
Configure Default IP addresses? [no]: yes
8) 是否使用TCP头压缩:
Configure for TCP Header Compression? [yes]:
9) 是否在异步口上使用路由表更新:
Configure for routing updates on async links? [no]: y
10) 是否设置异步口上的其它协议。
接下来,系统会对每个接口进行参数的设置。
1.Configuring interface Ethernet0:
1) 是否使用此接口:
Is this interface in use? [yes]:
2) 是否设置此接口的IP参数:
Configure IP on this interface? [yes]:
3) 设置接口的IP地址:
IP address for this interface: 192.168.162.2
4) 设置接口的IP子网掩码:
Number of bits in subnet field [0]:
Class C network is 192.168.162.0, 0 subnet bits; mask is /24
[1] [2] 下一页
四、常用命令
1. 帮助
在IOS操作中,无论任何状态和位置,都可以键入"?"得到系统的帮助。
2. 改变命令状态
任务 命令
进入特权命令状态 enable
退出特权命令状态 disable
进入设置对话状态 setup
进入全局设置状态 config terminal
退出全局设置状态 end
进入端口设置状态 interface type slot/number
进入子端口设置状态 interface type number.subinterface [point-to-point | multipoint]
进入线路设置状态 line type slot/number
进入路由设置状态 router protocol
&nbs